Find the Right Mount for Your Valve Positioner

513-677-8724

[email protected]

If you know the bracket and coupler you need select it below, or search for it in the below dropdown list.

Namur, 20 MM Shaft

Namur, 30 MM Shaft

Namur, 30 MM Shaft, 4" clearance

Please select your Mounting Configuration below:

Brand

MOUNTING FOR POSITIONERS

VRC brackets and couplers provide for a flush mounting of the positioner to the actuator, and offers some shielding to the actuator shaft and bearing area from contamination.

A single coupler (part number VM0029N-Mach) is used on all Namur style actuators with 20 mm (.787 inch) and 30 mm (1.18 inch) shaft heights.

Namur style actuators with a 20 mm (.787 inch) shaft height require Part Number VA0006-2.6 Bracket and Part Number VM0029N-Mach Coupler.

There are three brackets available for Namur style actuators with 30 mm (1.18 inch) shaft heights. The clearance required to fit over the shaft boss area will determine which bracket to use. They have 1.6 inch clearance (PN VK03), 2.6 inch clearance (PN VK03-2.6), and 4.0 inch clearance (PN VK03-4.0).

Brackets and couplers are available for Non-Namur actuators. Contact VRC with your requirements.

Limit Switch Warning

The VRC VI positioner has an integral I/P module that is approved for general purpose and hazardous
locations areas. The main positioner housing offers no protection for use in hazardous locations as defined by
the NEC (National Electrical Code).

For Transmitter and switch options
The use of the T1 or T2 transmitter is for use in only general purpose areas and not hazardous areas.

For limit switch requirements the S1 and S2 options can be used in accordance with the NEC (National
Electrical Code) in the following manor in hazardous locations.

The S1 and S2 switch options are simple passive sets of switches that can be used with the correct and proper
Intrinsically Safe barrier for the hazardous location. In addition, the S2 switch option is a set of hermetically
sealed glass to metal sealed switches that may be used in Division 2 areas as defined by the NEC (National
Electrical Code).
Important Note: In all Hazardous Locations insure your
installation meets all safety requirements of the NEC and
your local authority.

Position Transmitter Warning

For Transmitter and switch options

The use of the T1 or T2 transmitter is for use in only general purpose areas and not hazardous areas.

For limit switch requirements the S1 and S2 options can be used in accordance with the NEC (National
Electrical Code) in the following manor in hazardous locations.

Important Note: In all Hazardous Locations insure your installation meets all safety requirements of the NEC and your local authority.

Mounting for Valve Positioners

If you know the bracket and coupler you need select it below, or search for it in the below dropdown list.

Please select your Mounting Configuration below:

MOUNTING FOR POSITIONERS

About VRC

Product Navigation

Contact Us